Reverb lp careers3/7/2023 GAIN: Adjust the volume control of Low-Band Resonator. Slope set the charatcer of how the filter works and affects to the frequencies above and below the cutoff frequency.ġ2 dB/oct: clearer and brighter character.ĬF: Cutoff Frequency sets the frequency of the parametric Low-Band (60 - 300 Hz).ĮMPHASIS: Resonance parameter: Emphasis signal around the selected cutoff frequency of the Low-Band by adding feedback from the Low-Band filter output. The slope is measured in decibels of gain reduction per octave. SLOPE: A filter cuts the signal level at a specified frequency. The cutoff frequency is halfway between the slope of the decline on each side. MEDIUM-PASS: Combines LowPass and HighPass modes, saving signal sound in the middle. HIGH-PASS: Allows frequencies above the cutoff frequency value to pass through, but blocks frequencies below the cutoff frequency value. LOW-PASS: Allows frequencies below the cutoff frequency value to pass through, but blocks frequencies above the cutoff frequency value. PASS MODE: Original hardaware resonator section in early polysynth has a three-position PASS MODE switch that selects filter mode for all three resonator bands (Low, Medium, High). Try out this legendary 3-band resonator today. POLYRES audio processor is a 3-band resonant filter system, which reproduces the character of the musical sound used by many musicians and allows you to capture that nostalgic sound of 70s. Every sound at “The Model” by Kraftwerk makes use of the resonator section of the original synthesizer. POLYRES resonator are an exclusive audio effect, designed in the earliest era of audio processing in the synthesizer industry. Plus Slope modes (12 dB/oct or 24 dB/oct) which help incoming signals sound more clear and stable. POLYRES also includes original HighPass, LowPass and BandPass modes. POLYRES has the same three resonant filters with Cutoff, Emphasis and Gain controls for Low, Medium and High bands. This isn’t very useful for formant sounds because there aren’t any overlapping frequencies between the bands. While the effect sounds interesting, Resonators in the early era of polysyths were 6 db/oct filters that passed too many harmonics, resulting in a buzzy sound, even at maximum resonance. Turning up Emphasis for each band creates individual peaks ( resonances), called Resonators. Three individual resonant filters are band-limited, each with their own frequency range (LOW 60-300 Hz, MED 300-1500 Hz, HIGH 1500-7500 Hz). The resonators consist of three parallel filters, globally switchable between HP, LP and BP modes. POLYRES was inspired by the Resonators section in one of the first polysynths - Polymoog™ synthesizer.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |